IEC 61646 PDF

IECEE Certification & Testing | IEC Standards | IEC | General Information. NATIONAL FOREWORD. The Saudi Standards, Metrology and Quality Organization (SASO) had adopted the IEC “Thin-Film Terrestrial Photovoltaic (PV). IS /IEC Thin-film Terrestrial Photovoltaic (PV) Modules. РDesign Qualification and Type Approval. Report Reference No.

Author: Meztit Vozshura
Country: Austria
Language: English (Spanish)
Genre: Business
Published (Last): 18 May 2018
Pages: 30
PDF File Size: 14.72 Mb
ePub File Size: 17.85 Mb
ISBN: 315-1-69835-702-6
Downloads: 33057
Price: Free* [*Free Regsitration Required]
Uploader: Faelabar

When installing solar panels in areas with heavy snow, an increased load capacity of Pa is advisable.

IEC Standard – Home

The second part consists of the requirements for testing. For photovoltaic systems it suggests total insulation, which requires a special insulation iex the PV modules according to Safety Class II on the basis jec the following requirements:.

Solar system installers who do installation in areas with heavy snow should definitely use products with an increased load capacity: The IEC standard specifies the criteria for the design qualification and type approval of concentrator photovoltaic modules and assemblies suitable for long-term operation in general open-air climates.

It is crucial to use PV modules tested against salt mist corrosion certification in case the modules shall be installed near coasts or used for maritime applications.

  BUK444 PDF

When I buy a solar panel with IEC certification, does it mean the quality of the solar panel is good? A special certification for Concentrator PV CPV modules is necessary, because the high concentration of the solar irradiance through lenses or mirrors causes higher stress on the equipment.

Photovoltaic Solar Testing Specifications

I am a test engineer in SPV lab. An additional test takes the degradation behavior of amorphous silicon due to temperature and irradiance exposure into account. Then only the certification should be confirmed.

I have check IEC, but did not find the right information. Thank you very much.

The certifying authority should conduct the same tests on representative samples after the commercial production has started to confirm the quality on the commercially produced item. Nowadays many solar manufacturers produce according this requirement.

IEC | IEC Webstore | rural electrification, solar power, LVDC

Moreover, most certification bodies do not perform regular check ups after the certification has been issued, leaving in theory and praxis many opportunities for bad manufacturers to cut quality corners while on paper holding that certification. This includes all forces of nature:.

  BUSINESS ENGLISH HANDBOOK ADVANCED PAUL EMMERSON PDF

IEC tests at the time of applying for certification. Nevertheless, depending on where you want to install your panels, the certifications may still be required as per your national requirements or for example in order to apply for FIT. Photovoltaic PV module safety qualificationwhich was later issued as the European standard EN almost similar.

ied

Basically, certifications per se do not tell much about the quality of a kec. When testing, the prepared and submitted modules undergo HALTs highly accelerated life tests that are not representative of standard real-world conditions. Or do I also need IEC ?

This has been included in the IEC ed. Its purpose and methods. Solar installers that are operating in a highly corrosive atmosphere such as near the sea, the resistance of PV panels against the corrosive effects should be checked.

Niclas is absolutely correct.